Skip to content

Critical-facility support

Compressed Air for Data Center Facility Controls

Where a data center has pneumatic actuators, control valves, dampers or maintenance equipment, a correctly specified compressed-air system can support those facility functions. Compressed air is not the primary method of cooling server equipment.

Direct answer

What is compressed air used for in a data center?

In facilities equipped with pneumatic devices, compressed air can power control actuators, valves, dampers and some maintenance tools. Actual use varies by mechanical design; many data centers use electronic actuation and may not need a dedicated compressed-air plant.

Where air fits

Understand the Operating Situation

Facility-air demand must be traced to actual equipment. Controls for valves or dampers may require relatively low continuous flow but reliable pressure and clean, dry air. A separate maintenance connection can have an intermittent demand profile.

For critical mechanical systems, evaluate standby capacity, air-storage autonomy, power availability, alarming and maintenance isolation with the facility engineer. Do not infer a compressor rating from rack count or IT load.

Where compressed air is used

Typical Air-Powered Functions

Functions depend on the specific facility and installed equipment.

01

Pneumatic control actuators

Some facilities use pneumatic actuation for HVAC dampers, valves or other mechanical plant devices; confirm the installed controls first.

02

Maintenance and service stations

Approved pneumatic tools and service connections can introduce short-duration demand separate from instrument air.

03

Mechanical-room isolation and monitoring

Pressure regulators, dryers, filters, receiver storage and alarms may be needed if the facility design specifies an instrument-air supply.

Engineering requirements

What to Verify Before Selecting a Compressor

Compare actual conditions against manufacturer specifications. Air treatment and distribution are part of the same system.

Selection factorVerification required
Actual connected devicesInventory pneumatic valves, actuators and tools and identify which require continuous, intermittent or emergency air.
Pressure and reliabilityVerify minimum pressure at devices, acceptable outage time, standby philosophy and site electrical requirements.
Water and oil limitsObtain component-maker limits; specify the appropriate dryer and filtration at the point of use.
Storage and controlReview receiver sizing, automatic changeover, demand peaks and monitoring rather than sizing from horsepower or IT megawatts.

Sullivan-Palatek equipment

Compressor Families to Evaluate

These are conditional equipment starting points, not approved final selections or capacity guarantees. Only existing published product pages are linked.

Published Compressor Models and Series

  • SPM Series 5-10 HP

    A compact fixed-speed industrial family to compare if the measured facility-air requirement is within its published ratings.

  • SP11 Series 25-40 HP

    A larger industrial series to assess where confirmed airflow and duty justify it.

  • VFD Compressor Series

    Consider speed control if measured demand varies; use rated model data and a load profile.

Air Treatment and Performance Documents

Helpful answers

Frequently Asked Application Questions

Does every data center need an air compressor?

No. Compressed air is needed only when the facility design includes devices or service operations that require it; many actuation systems are electric.

Can a standard rotary screw compressor cool data center servers?

No. A conventional facility-air compressor supplies pneumatic or service air; server heat removal relies on dedicated cooling systems.

Which compressor is suitable for data center controls?

Compare a published Sullivan-Palatek SPM, SP11 or VFD family only after confirming actual flow, required pressure, air quality, redundancy and available power.

Should facility controls have backup air?

If loss of control air would interrupt a critical function, the designer should assess receivers, standby compressors, controls, power and alarms against the site risk requirements.

Planning an equipment request

What to Share With a Compressor Specialist

  1. List of actual pneumatic controls and their air consumption
  2. Minimum device pressure and required air purity
  3. Required standby duration and alarm strategy
  4. Available voltage, ambient conditions and space constraints

Next step

Build Around the Actual Air Demand

Bring the required CFM, PSI, duty cycle, air quality and electrical information. Sullivan-Palatek can help you compare relevant published equipment and system components.